CASEA Casufloor DE – Alpha Fine Flow

CASEA Casufloor DE is a calcium sulphate based, polymer-modified, levelling screed compound, ideal for renovations or levelling cementitious, calcium sulphate and concrete based floors.

The composition of the material makes it ideal to use overheated floor systems. Normally used for thickness 10 to 30 mm bonded, however may be used up to 60mm application thickness.

The material complies with EN 13813: 2002 and is CE marked. Designation: CA-C30-F7.Casufloor DE is a calcium sulphate based, polymer-modified, levelling screed compound, ideal for renovations or levelling cementitious, calcium sulphate and concrete based floors. The composition of the material makes it ideal to use over heated floor systems, layer thickness 10 to 60 mm. The material complies with EN 13813: 2002 and is CE marked. Designation: CA-C30-F7.

Casufloor DE is used in renovation of apartments, offices and public buildings as a levelling material and is suited for use with Roth’s QE Underfloor Heating System and Lewis® Deck Dovetail Sheeting System. The screed is for internal use and can be covered with
all common floor coverings. If a cement based adhesive or smoothing compound is required, the surface of the screed must be sealed first using an appropriate acrylic primer/sealer.

It is not suitable for wet rooms.

Related Downloads

icon-pdf  TDS CASEA Casufloor DE Alpha Fine Flow

icon-pdf  SMET Floor Screeds and Compounds Product Selector

NBSplus National Building Specification Clause

Benefits of CASEA Casufloor DE – Alpha Fine Flow

• Smooth Laitance Free Finish
• Pumpable – High Flowability
• Early Trafficking
• Very Low Shrinkage
• Reduced Drying Times
• CE Marked
• EN 13813: 2002

Technical Details CASEA Casufloor DE – Alpha Fine Flow

Screed Specification

CA-C30-F7 EN 13813: 2002

Maximum Thickness 60mm
Minimum Thickness Bonded: 8mm. Pipe die-cut steel sheets underfloor heating systems: 10mm
Use Internal use only
Grain size 0 – 2 mm
Compressive Strength (28 days) > 30 N/mm²
Flexural Strength (28 days) > 7.0 N/mm²
Flow Rate 250 – 280 mm (Hägermann cone)
Modulus of Elasticity approx. 18 kN/mm²
Hardening Time (Light-foot traffic) 24 hours
Hardening Time (final covering) 1 day to 2 weeks depending on thickness and site conditions
Recommend water content 16 – 19 %
Thermal Conductivity λR = 1.40 W/mK
Yield 1.8 kg/mm/m²
Water Requirement approx. 4 – 4.5 l per 25 kg bag
Consumption approx. 18 kg/m² per 1 cm applied thickness approx. 62 kg/m² per 3.5 cm applied thickness. (Roth QE-system)
Packaging 25kg bags

SMET stock a wide range of screeds, and binders, including SMET LiteFlo Lightweight screed, which is 30% lighter than a traditional screed, and Rapid set screeds, which reduce overall drying time.

Packaging: Available in 25kg bags, 42 bags per pallet